JavaScript is disabled. For a much better experience, please allow JavaScript in her browser prior to proceeding.


You are watching: How do you check the transmission fluid on a ford escape

Sorry if this sounds redundant but what is the right method to examine the oil level on my 08 Ford escape 3.0L cd4e. Some people said check when the transmission is cold, others have actually said to drive 30 km then inspect dip stick?Can anyone melted some light? I"ve noticed as soon as the infection is cold, 2 Celsius outside, the oil proper reads on dipstick yet when I heat the trans to regular operating temperature, the oil is whereby it need to be.Anyone? :worry:
*
*
*
*
*

*

*

I understand all my vehicles say "CHECK HOT" top top the dipstick. Mine Escape go not have a infection dipstick though, together the transmission is sealed.
What perform you median your infection is sealed??? Look because that the dipstick and also check her tranny oil! who told you it to be sealed? exactly how are you supposed to understand if the oil is in ~ the best level? exactly how would you change it? have you review your owner manual?


See more: What Is Heavier Water Or Sand, Which Is Heavier, Wet Or Dry Sand

TRANSMISSION FLUIDChecking electronically managed continuously variabletransmission (eCVT)Refer to your booked maintenance details chapter forscheduled intervals for liquid checks and changes. Her transaxle walk notconsume fluid. That is design to be filled for life. However, the liquid levelshould be confirm if you an alert some authorize of liquid leakage.Automatic transmission fluid broadens when warmed. To achieve anaccurate liquid check, drive the vehicle until the is warmed up(approximately 20 miles <30 km>). If your vehicle has beenoperated because that an extended duration at high speeds, in city trafficduring warm weather or pulling a trailer, the car should beturned turn off for about 30 minutes to allow fluid come cool beforechecking.1. Journey the auto 20 mile (30 km) or until it reaches normal operatingtemperature.2. Park the car on a level surface and engage the parking brake.3. With the parking brake engagedand her foot ~ above the brake pedal,turn the an essential to the ACCESSORYposition but do not begin the engine.Turn the wheel come the left to gainaccess come the inspect plug.4. Latch the gearshift lever in ns (Park) and also make certain that the engine isOFF by put the ignition in the Lock position.2008 escape Hybrid (ehv)Owners overview (post-2002-fmt)USA (fus)Maintenance and Specifications2845. Using the feet in the splashshield, eliminate the inspect plug fromthe next of the transmission.If this is the first check the thetransmission fluid, it may benecessary to remove the perforatedsection of the splash shield (asindicated top top the splash shield).6. Be certain the engine has been stopped for at least 3 minute beforeperforming the fluid level check.The liquid level have to be within1/4 inch (6 mm) that the plug threads.8. Replace the examine plug.Adjusting eCVT fluid levelsBefore adding any fluid, make sure the correct type is used. The type offluid provided is suggested in the maintain product specifications andcapacities section in this chapter.Use the a non-approved liquid may reason internal transaxlecomponent damage.If the fluid level is low, include fluid with the check port until the level iscorrect and fluid starts to operation out that the transmission. If one overfilloccurs, excess liquid should be removed by allowing the liquid to run outof the inspect port.A serious overfill problem of transmission fluid may causedamage.Do not usage supplemental transmission fluid additives, therapies orcleaning agents. The use of these materials may influence transmissionoperation and result in damage to interior transmission component