Spherical Bearing Ford Focus 2 It is not subject to restoration and when leaving the building requires an immediate replacement together with the hub!


The process of changing the front-wheel bearing support mechanism Ford Focus 2

*
Wheel bearing is one of the majorElements of the suspension of any car and its work depends not only on comfort, but also on the safety of movement. This fact should be taken into account, before proceeding to repair. On the car Ford Focus 2 the roller of the closed type which is tightly fixed on a stupid case is established, therefore and it needs to be changed together with it.

You are watching: Ford focus front wheel bearing change instructions


To change the bearing it is necessary to makeSimple procedure for removing the trunnion and dismantling the damaged device. After this, a new bearing is installed, pressed onto the new hub. Remember: separately the sliding element is not installed, and the damaged part can not be repaired for the purpose of further operation.

Naturally, this design is expensive, but the money is compensated by the rapid installation of a new part and the maximum reliability of the structure.


Analyzing the advantages of replacing the finished hub unit, we can distinguish the following:

The possibility of improper assembly of nodes is minimized; Great endurance of the new node; Quick replacement, which does not require special skills and adaptations.

What can not you do without when replacing the wheel bearing on the Ford Focus 2?

Before starting the repair, it is necessary to carefullyTo study the suspension and the chassis of the car, errors in the repair of these systems are unacceptable and can cost lives. After this, carefully prepare the car: wash, dry and install the machine on a level surface of the garage, of course, do not forget to take care of the chillers in order to avoid the spontaneous movement of the car. In addition, be sure to prepare the following parts and accessories:


A new hub, in a set - 2 pieces; A jack of any type; Set of keys and pullers; lubricants;

Once everything is prepared and youReady to begin the replacement process: note: the bearing is very tightly pressed into the cavity of the pivot and its removal can cause you a lot of questions, do not despair and take up a sledgehammer, you will quickly squeeze it out with a jack.

Step-by-step instruction

Since the wear of the wheel bearings on the car is relatively even, it is more practical to change the bearing of the Focus 2 hub directly on both wheels.


The wheel bearing on Ford Focus 2 changes in the following sequence:

The wheel is removed; Pressing and lubricating the steering tip; Unscrews and lubricates the hub drive; The brake calliper and brake hose are disconnected; Ball pressing is pressed out; Unscrews and removes the trunnion; Channels and joints of the rotary knuckle are cleaned, knots are lubricated; Under the influence of the press, the hub is evenly fitted into the cavity of the pivoting mechanism.

At this the installation process can be considered finished and you can start assembling the suspension, which is carried out in the opposite order to the disassembly.

See more: How Long Does Taco Meat Last In The Fridge ? Cooked Seasoned Taco Meat

Follow all the above tips, and you can easily and quickly repair your Ford suspension without resorting to expensive SRTs, while gaining invaluable mechanic experience.