JavaScript is disabled. Because that a far better experience, please permit JavaScript in her browser prior to proceeding.

You are watching: Chevy 6.0 oil pressure sensor location


ok so mine oil pressure sensor went out.I searched online for information on how to readjust it.seen short articles from that is simpler to traction the intake, or friend risk reduced up hands from trying come barely reach in to gain to the sensor.all through an typical replacement time that 45min come a few hours depending upon if you wanted cut up hands or not...i"m right here to to speak those posts and suggestions room are BULL...I changed my sensor in much less than 10 min. No cut up hands, no pulling the intake. All on a warm motor.YOU need to install the expansion after the socket and universal is put onto the sensors, and also the ratchet after that, and also must be taken turn off that means too....TOOLS NEEDED:
*

*

*

*

pull +pos battery cable off. Through the 10mm wrench/setuppull the plastic engine sheathe off.wrap a pair wraps of thread tape onto the brand-new sensorhop increase on the core support with the 1/2" devices and new sensorfind the VACUUM water tap on the brake booster follow that earlier to the engine, where it meets a bracket the sensor is directly below the hose.reach under the hose and also around the bracket come unhook the wires for the sensor
*

NOWhook the universal to the socket, and place that onto the sensornow hook the 6" extension to the universaland lastly hook the ratchet to it.YOU need to install the extension after the socket and universal is placed onto the sensors, and the ratchet after that, and also must be taken off that method too....

See more: Why Is The Standard Deviation Used More Frequently Than The Variance ?


NOW angle the setup for this reason the expansion is together close come the brake booster vacuum hose and loosen the sensor till the ratchet stops clicking the reset(means the sensor is loose enough to revolve by hand)pull turn off the ratchet, then the extension, climate the universal and socketremove the sensor the rest of the way by handnow take the brand-new sensor with the subject tape placed on itand reach back and begin to thread it in, obtain it as much as you deserve to by hand(mine went all the means down come the washers by hand)NOW location the socket and universal top top it, then the extension, and finally the ratchet.YOU should install the expansion after the socket and universal is placed onto the sensors, and also the ratchet after that, and also must be taken off that means too....angle the setup therefore the expansion is as close to the brake booster vacuum hose and tighen the sensor(((**** NOTE:::: you carry out NOT should put loads of pressure on the sensor the is why the is subject tapped and has twin washers on the a good snug to the right is every you need, dont monkey it on....remove the ratchet, then the extension, then the universal and also socket.YOU must install the expansion after the socket and universal is put onto the sensors, and also the ratchet after ~ that, and must be taken turn off that way too....reach back behind over there again grab the wire connector, then feel around on the sensor because that the "shark fin" ~ above the sensor, heat it up through the tab on the wire connector and push that on.your done v that part. Friend can acquire down off the trucknow take her engine cover, make certain the 2 rubber grommets space on it, if not they room still top top the mounting studs top top the engine(pull lock off and also put lock on the cover)put it earlier on,
now install the battery cable back on and tighten down with the 10mm.you room now completely finished.