Hello, Exit the automobile and also lock it and also let it sit for 30 minutes. Then use the fob to unlock it and it must be reset. Also you have the right to execute tough reboot by emotional the negative battery cable to the positive battery terminal to discharge the capacitors. Here is a overview that can helps too.https://www.bsci-ch.org/articles/how-to-reset-a-security-systemPlease let us know if you require anypoint else to obtain the problem fixed.


You are watching: 1999 ford explorer anti theft system reset


Drove it fine yesterday and a frifinish played with the locks in the car currently it wont revolve over. Its the original essential and also the battery is fine in it.
*

Have you locked and unlocked the door via the key? That typically will certainly recollection them...Have you checked for power at the starter solenoid? May be a coincidence that the starter is bad See the guide listed below on utilizing a test light, it is a good means to examine for power at the small trigger wire on the solenoidhttps://www.bsci-ch.org/articles/how-to-use-a-test-light-circuit-testerAttached listed below is the wiring diagram for your beginning circuit
*


I have actually a 1999 ford explorer 2wd 5.0 4dr.86000mi. After unlocking doors via remote alarm goes off as soon as door is opened up. This is the manufacturing facility alarm mechanism. Is tright here a method to diaffix the alarm altogether?

Which device execute you have actually, PATS or active? Or both?(Not certain if this is available). Does your essential have actually the chip(pats)? If you have actually the active, make sure all your door switches and also such are not hanging up, might have to have actually it diagnosed by knowledgeable perboy, this mechanism can be checked through a scanner qualified of reading pid"s and also so forth, also the ngs tester. There"s a pair of modules, rap and also gem, that also play a component in this sytem, inspect all the straightforward stuff initially. You might have to have someone look at it, without the correct diagnostic routines, may be hard to number out. Hopefully it"s something straightforward. Does the keyless entry system still work? You can try unhooking the battery + cable and re-installing it.
You asked if the ignition had the chip remote-it does not. The keyless enattempt does work-related as does the panic alarm button. Just can not disarm through remote. Thankyou.
The alarm on my 1997 Explorer goes off at odd times. Often within secs after locking it (either manually or via the remote). Occaisonally it will certainly go off in the middle of the night. It is maintained in the locked garage so no one is messing through it. It just goes off. What could be causing this? Is it something I can deal with myself or does it should go to the dealer?
You deserve to settle it yourself. You might want to revolve down the senstivity on the alarm. This is not an after industry alarm is it?
How carry out I revolve down the sensitivity? It simply began doing this in the last 6 months and it"s fairly sporadic. It might go off 2 0r 3 days in a row and also then not aget for a couple of weeks.
1996 Ford Explorer 6 cyl Four Wheel Drive Automatic i have actually a 96 ford traveler. The alarm goes off in the midddle of the night without setting the alarm what do I do. I look online and they sassist to unplung the connector in rear kick side panel. If I unplung it the car wont start yet I tride it. I unplung one and it starts and the various other and it starts. Is it ok to unplung one or the various other. I require Aid BAD I dont Got Money To resolve it.
I hate to say it, however you should take it to a dealer. Tbelow are a few things that can reason it and also they are the only ones with the proper test equipment.


See more: Santana Moss Is Santana Moss Related To Randy Moss Play For?

Electrical problem1999 Ford Explorer 6 cyl Four Wheel Drive Manual New milesHiI Have been doing up a 10/"99 xl Explorer. It was badly treated and also needed a brand-new motor. Installed brand-new motor and also started it up. All good. As it sat in the shed waiting for the rest of the makeover it would certainly intermittingly not begin and also then begin. Took it to the auto electricians to gain some wiring done and so on Turns out it demands one more blinker switch combicountry which I obtained secondhand and they reput it. They were moving the auto around the yard as need be and also then it would"nt begin. It was no longer intermittingly and also the anti - theft light was continuing to be on while cranking over. The Electrician apparantly had actually the essential etc. Tested and also they were fine so I"m wondering if while the blinker combination switch was being replaced somepoint occurred in that location to sheight the automobile from founding alltogether. I"m reasoning of placing an additional ignition switch in anyway? My auto electrician is pulling his hair out and so am I as he has had the car tbelow for a pair of months and we would certainly all love to gain to the bottom of this problem.Hope you deserve to helpPlowy